Display Equal high/ low, alert when liquidity is taken.. or created !

An innovation that flows a bit if you are an SMC trader and which was actually missing on TradingView: identification of equal high/low, alerts when liquidity is taken... or created!
Its choice in the design means that it gives more importance to the last identified pivots: that is to say that it will display more recently created liquidity than old one! Perfect for identifying market inducement mechanisms (SMC) under an area of ​​interest. This is a typical pattern of induction and false breakout: 2 hits, the break, reintegration, and real move :

Quick exemple on BTC, you are alerted by liquidity created:

Then we grab, and deep. :)

You can display "old broken lines" for backtesting. Careful, it actually display lines when pivot is detected and broken at the same time : it's false. checks that the line has been touched twice :) So, some false lines in the backtest but it does not affect the indicator at all.

You can set number min of pivot at 1 to plot current high/low untested !


Most aggressive TradingView/MT4/MT5 trading setup on the market. Pure juice concentrated from SMC/ICT, divergences and PA!

Snipe the institutional levels! 🐋🏹
Skrypt tylko na zaproszenie

Dostęp do tego skryptu mają tylko użytkownicy upoważnieni przez autora i zazwyczaj wiąże się z opłatą. Możesz dodać go do ulubionych, ale będziesz mógł z niego korzystać dopiero po uzyskaniu zgody jego autora. Aby uzyskać więcej informacji, skontaktuj się z astre_ts, lub postępuj zgodnie z poniższymi instrukcjami autora.

TradingView sugeruje, abyś nie płacił za skrypt i nie używał go, jeśli nie ufasz autorowi w 100 % i nie rozumiesz, jak działa skrypt. W wielu przypadkach można znaleźć dobrą alternatywę open-source za darmo wśród naszych Skryptów Społeczności.

Wyłączenie odpowiedzialności

Informacje i publikacje przygotowane przez TradingView lub jego użytkowników, prezentowane na tej stronie, nie stanowią rekomendacji ani porad handlowych, inwestycyjnych i finansowych i nie powinny być w ten sposób traktowane ani wykorzystywane. Więcej informacji na ten temat znajdziesz w naszym Regulaminie.

Instrukcje autora

Follow @astre_ts for more informations, contact & assistance at telegram !

Chcesz użyć tego skryptu na wykresie?

Uwaga: przeczytaj to, zanim poprosisz o dostęp.