SSYS: Will it make a new all time low?
Zaktualizowano
Figured I'd keep the trend of 3D printing stocks going. This is one I bought after the "crash" and just sold for a loss. After seeing it not reverse I felt I should re evaluate my analysis and see where I went wrong. I thought the correction was over at the 11.91 low. bought on a setup on the 1hr which initial looked good, but then became a flat to continue down. I'll post that in the comments.
I see some inverse correlation between this and the 2 other print stocks I follow DM, and NNDM. It looks like both of those are getting ready to continue on the uptrend, and this one looks like it will continue down to make another low. After this happens I'd like to look for buy setups again. Until then I'm watching for a correction within this bearish impulse to confirm my current count.
What's your favorite 3D printing company? Thanks for looking!
I see some inverse correlation between this and the 2 other print stocks I follow DM, and NNDM. It looks like both of those are getting ready to continue on the uptrend, and this one looks like it will continue down to make another low. After this happens I'd like to look for buy setups again. Until then I'm watching for a correction within this bearish impulse to confirm my current count.
What's your favorite 3D printing company? Thanks for looking!
Uwaga
Uwaga
Powiązane publikacje
Wyłączenie odpowiedzialności
Informacje i publikacje przygotowane przez TradingView lub jego użytkowników, prezentowane na tej stronie, nie stanowią rekomendacji ani porad handlowych, inwestycyjnych i finansowych i nie powinny być w ten sposób traktowane ani wykorzystywane. Więcej informacji na ten temat znajdziesz w naszym Regulaminie.